Hi,
I am seeing packet lost when doing a PING from BR1 router to CCM Servers.
Wondering anyone else faced the similar issue during their rack session..
Thanks..
P1-BR1-RTR#PING 10.1.200.20 SO VLAN 210
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.200.20, timeout is 2 seconds:
Packet sent with a source address of 10.1.201.1
!.!.!
Success rate is 60 percent (3/5), round-trip min/avg/max = 752/797/880 ms
P1-BR1-RTR#
P1-BR1-RTR#
P1-BR1-RTR#PING 10.1.200.20 SO VLAN 210
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.200.20, timeout is 2 seconds:
Packet sent with a source address of 10.1.201.1
.!...
Success rate is 20 percent (1/5), round-trip min/avg/max = 804/804/804 ms
P1-BR1-RTR#
P1-BR1-RTR#SH INT S0/1/0
Serial0/1/0 is up, line protocol is up
Hardware is GT96K Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 4/255
Encapsulation FRAME-RELAY IETF, loopback not set
Keepalive set (10 sec)
LMI enq sent 21, LMI stat recvd 21, LMI upd recvd 0, DTE LMI up
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 0 LMI type is ANSI Annex D frame relay DTE
FR SVC disabled, LAPF state down
Broadcast queue 0/64, broadcasts sent/dropped 58/0, interface broadcasts
57
Last input 00:00:03, output 00:00:03, output hang never
Last clearing of "show interface" counters 00:03:33
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 30000 bits/sec, 28 packets/sec
5 minute output rate 0 bits/sec, 1 packets/sec
6415 packets input, 964489 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
249 packets output, 24045 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
