I just logged into pod 26 for my afternoon session. I will let you know if i have problems.
Scott Hardesty | Cisco Engineer | MidAtlantic | Presidio Networked Solutions 7601 Ora Glen Drive, Suite 100, Greenbelt, MD 20770 | mailto:[EMAIL PROTECTED] D: 301.313.2041 | C: 443.789.1219 | http://www.presidio.com/ -----Original Message----- From: Trevor Peddle <[EMAIL PROTECTED]> Sent: Friday, October 24, 2008 4:16 PM To: ccie_voice@onlinestudylist.com <ccie_voice@onlinestudylist.com> Subject: Re: [OSL | CCIE_Voice] Pod 26 - BR1 NM-16ESW port config I have had many replies and verification of my configuration, thank you all for that. Yes the VLANs were ceated and verified I could also ping the VLAN interfaces. So the scenario is this the interfaces and vlans are configured correctly as is the DHCP scope. The phones pick up an address from DHCP and then drop it, if I shut/no shut the interfaces they will pick up the DHCP ip again and then drop it. I cleared CDP else the IP would stay there. This has happened to me 2 days running I wonder if the module could be checked ? I definatley went over the 10 minute troubleshooting rule on this one ........ ________________________________ From: Trevor Peddle <[EMAIL PROTECTED]> To: ccie_voice@onlinestudylist.com Sent: Friday, 24 October, 2008 18:55:24 Subject: [OSL | CCIE_Voice] Pod 26 - BR1 NM-16ESW port config Hi all, I have configured the phone ports on BR1 as follows, they get an IP from the DHCP scope on CUCM server which I can see also with CDP on the router. However they are not contactable via IP, if I clear the CDP table the addresses disapear. I can ping the default gateway, it is correct in DHCP as is the net mask. I sometimes get a response via ping but probably a couple out of the blue now and again. The VLAN interfaces's are set correctly because I can see them ok. interface FastEthernet1/0 switchport trunk native vlan 360 switchport mode trunk switchport voice vlan 460 interface FastEthernet1/8 switchport trunk native vlan 360 switchport mode trunk switchport voice vlan 460 I configured "switchport trunk encapsulation dot1q" but it does not show in the config I also tried just as an access port with access vlan and voice vlan, also without success. This seems such an easy issue as I have never had such issues before when configuring similar ? I know my brain is swimming at the moment, first lab attempt on 6th Nov, but I do not think I have missed anything? I had the same problem on the same pod yesterday.