Thks Larry and Tech Guy, The reason I asked this, I used remote rack from InternetworkExpert, and it behave differently from what the real CCM do.
For example: - GW will not register after u change the MAC (and change back again for testing purpose) even after CCM restart and GW reset - Can not use to register phone to SUBSCRIBER for redundant test - very slow response to Call Manager screen, etc Did you guys not experience these or other issue when using the remote lab ? that I think different from real Call Manager or maybe any workaround for this VM cluster ? Thks, >* Even if you go to a lab location that the equipment is physically there, *>* you cannot touch it. It will generate noise near you. *>* *>* Other than that, you will be so focused on the config screens and the lab *>* book that you would probably not know if there was a rack of equipment in *>* the same room as you or not. *>* *>* As long as the rack that you are working on meets ALL of the current lab *>* requirements ( IOS versions, hardware platform, etc. ) you should be fine *>* without seeing it. *>* *>* Even when you take a bootcamp class, the equipment may or may not be in the *>* same location as where you are. If it is in the same location, most likely, *>* it will be in another room to isolate you from the distraction of the noise *>* and heat. *>* *>* Larry Hadrava *>* CCIE #12203 CCNP CCNA *>* Sr. Support Engineer – IPexpert, Inc. *>* URL: http://www.IPexpert.com <http://www.ipexpert.com/> < http://www.ipexpert.com/> *
