In the CallManager, go into the gateway PRI port and click "reset".
Then telnet or console into the gateway and issue the global configuration command "no mgcp". Wait 5-10 seconds and then type "mgcp". Follow the procedure whenever you need to reset the MGCP gateway in the lab. You want to do both steps. Brian On Fri, May 22, 2009 at 11:49 AM, ABIOLA ADEFILA <adefilabi...@gmail.com> wrote: > so what am i to do? > thanks > > On Fri, May 22, 2009 at 4:24 PM, Brian Valentine <bkvalent...@gmail.com> > wrote: >> >> Have you been resettting the mgcp gateway in ccm and not resetting it in >> the CLI? Any time you reset the mgcp gateway in ccm, you'll need to reset >> it manually by doing "no mgcp" and then "mgcp". >> >> This is the case because you can't run the "ccm-manager config" >> commands... since you are using a partial PRI and callmanager doesn't >> understand partial PRIs. >> >> Brian >> ----- Original Message ----- From: ABIOLA ADEFILA >> To: ccie_voice@onlinestudylist.com >> Sent: Friday, May 22, 2009 9:22 AM >> Subject: Re: [OSL | CCIE_Voice] REGISTERING WITH CALLMANAGER >> >> >> Anyone with an info >> >> >> On Fri, May 22, 2009 at 1:16 PM, ABIOLA ADEFILA <adefilabi...@gmail.com> >> wrote: >> >> Hello, >> >> i have the voice gateway configured as MGCP. >> >> when i do sh ccm-manager, it registered after a while i keep getting >> registering with CM and endpoint is now showing unknown >> >> i need support on this >> >> >> > >
