Thanks Otto. I think everything was correct but I did not add CTI ports in
CUE itself :) Just looked at that and got everything working.

On a side note - I think IPX should add this in the PG so folks don't get
confused.

Thanks for your help again


On Sat, Mar 20, 2010 at 10:27 AM, Otto Sanchez <[email protected]> wrote:

> Hello,
>
> Have you tried calling the vm using only g.711?, in that way you can
> discard whether it is a problem with vm integration itself or a transcoding
> issue. Also, are your cti route points and ports registered?, does the issue
> only happens when calling from remotes sites?, is the transcoding being
> invoked?, are there any qos policies in place?,
>
> Thanks,
>
> On Fri, Mar 19, 2010 at 10:39 PM, CCIETalk.com <[email protected]> wrote:
>
>> wow am I the only one having this issue? cue is registered, transcoder is
>> registered so I am not sure what I might be missing unless PG missed
>> something.
>>
>>
>> On Fri, Mar 19, 2010 at 10:12 PM, CCIETalk.com <[email protected]>wrote:
>>
>>> I followed the PG on this one to the last dot but I cannot get the calls
>>> to ring the VM. After completing all the tasks, PG instructs to dial from HQ
>>> or BR1 and call fwd to BR2 but I get a busy signal.
>>>
>>> I can see that my CUE is registered to CUCM.
>>>
>>> Any clues?
>>>
>>> --
>>> www.ccietalk.com
>>>
>>
>>
>>
>> --
>> www.ccietalk.com
>>
>> _______________________________________________
>> For more information regarding industry leading CCIE Lab training, please
>> visit www.ipexpert.com
>>
>>
>
>
> --
> Regards,
>
> Otto Sanchez
> CCIE #25592 (Voice)
> Support Engineer - IPexpert, Inc.
> URL: http://www.IPexpert.com
>



-- 
www.ccietalk.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit 
www.ipexpert.com

Reply via email to