Maybe a codec selection issue. Do you have any restrictions on CUCM (Regions, Locations) that would disallow the call setup?
On Sat, Jun 12, 2010 at 11:03 AM, jammer jones <jammerjone...@gmail.com>wrote: > What would cause the following issues with a gw configured as h323 to cucm > > outbound calls work just fine > > inbound calls from a pstn phone does not work. PSTN phone displays unknown > number and then a fast busy - this is the problem. > > when in srst mode outbound and inbound calls work just fine. - this makes > me believe it is something in cucm. I verified the config on the gateway in > cucm 6 times. > > > My config on the gateway was this. > voice translation-rule 1 > rule 1 /.*\(....\)/ /\1/ > > dial-peer voice 1 pots > translation-profile incoming frompstn > incoming called-number . > direct-inward-dial > port 0/0/0:23 > > card type t1 0 0 > network-clock participate wic 0 > isdn switch-type primary-ni > > controller t1 0/0/0 > pri-group timeslots 1-24 > > inter ser 0/0/0:23 > isdn outgoing display-ie > isdn outgoing ie redirecting-number > > interface vlan 302 > h323-gateway voip bind srcaddr 1.1.1.1 > > dial-peer voice 100 voip > destination-pattern 3...$ > session target ipv4:2.2.2.2 > dtmf-relay h245-alphanumeric > no vad > > > dial-peer voice 101 voip > preference 1 > destination-pattern 7...$ > session target ipv4:2.2.2.1 > dtmf-relay h245-alphanumeric > no vad > > > config on cucm was all of the usual. I verified i was pointing to 1.1.1.1 > several times, verified i had a correct inbound css on gateway, etc.. > > > the debug isdn q931 showed invalid information element. > the debug cch323 h225 showed what appeared to be a proper call flow. > > > Unfortunately i am unable to reproduce the same behavior so i do not have > better debug messages. > > > could something me set coming in from the telco that would break inbound > calls going to phones registered to cucm, but not phones registered to srst? > > > > Thanks > > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com