Dear Graham , I am calling remote device , i am trying to call on the same router where pri is terminated.
with command isdn test call interface serial0/1/0:15 xxxx but getting the error no route to destination -------- while debugging isdn standard and q321 . I tried google that says This cause indicates that the called party cannot be reached because the network through which the call has been routed does not serve the destination desired. This cause is supported on a network dependent basis. Regards On Fri, Jul 23, 2010 at 12:52 PM, Graham Hopkins <ghopk...@wolf-rock.co.uk>wrote: > Do you have access to the device you are calling ? > Are you sure it is setup and ready to receive the call ? > Call it from a handset - you should hear it ring even if the call cannot > complete as it's ISDN end to end > > The problem may be with the provider but it could also be with the > terminating device > > Graham > > On 23 Jul 2010, at 06:37, Akbar Ali <ccie...@gmail.com> wrote: > > Dear Bo , > > i am pri only for backup of mpls link , but first i am trying to test my > link from router itself. > but getting error that says no route to destination . provider is not ready > to accept that this is their problem. > > > Regards > > Akbar > > On Thu, Jul 22, 2010 at 4:55 PM, Bo Gao <bga...@gmail.com> wrote: > >> Do you need to set isdn incoming-voice voice on D channel? >> >> >> >> >> >> On Thu, Jul 22, 2010 at 2:49 AM, Akbar Ali <ccie...@gmail.com> wrote: >> >>> Dear all , >>> >>> I am getting unexpected error while configuring isdn pri E1 , that i am >>> not able to understand >>> as provider says everything is right from their side what to do please >>> help me. >>> following is my configuration and errors also ... >>> >>> i tried self test on pri... >>> >>> controller E1 0/1/0 >>> pri-group timeslots 1-31 >>> description +++++BSNL PRI+++++ >>> interface Serial0/1/0:15 >>> no ip address >>> encapsulation ppp >>> dialer rotary-group 1 >>> dialer-group 1 >>> isdn switch-type primary-net5 >>> no peer default ip address >>> ppp authentication chap >>> >>> interface Dialer1 >>> ip address 10.130.253.254 255.255.255.0 >>> encapsulation ppp >>> no ip mroute-cache >>> dialer in-band >>> dialer idle-timeout 99999 >>> dialer map ip 10.130.253.252 name FIS_HCBLROUTER broadcast >>> dialer load-threshold 1 either >>> dialer-group 1 >>> >>> >>> HO-Rtr#sh log >>> Syslog logging: enabled (0 messages dropped, 105 messages rate-limited, >>> 0 flushes, 0 overruns, xml disabled, filtering disabled) >>> No Active Message Discriminator. >>> >>> No Inactive Message Discriminator. >>> >>> Console logging: level debugging, 55360 messages logged, xml >>> disabled, >>> filtering disabled >>> Monitor logging: level debugging, 0 messages logged, xml disabled, >>> filtering disabled >>> Buffer logging: level debugging, 55463 messages logged, xml >>> disabled, >>> filtering disabled >>> Logging Exception size (4096 bytes) >>> Count and timestamp logging messages: disabled >>> Persistent logging: disabled >>> Trap logging: level informational, 741 message lines logged >>> Log Buffer (4096 bytes): >>> *Jul 22 09:05:01.697: ISDN Se0/1/0:15 Q921: User RX <- RRp sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:01.701: ISDN Se0/1/0:15 Q921: User TX -> RRf sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:11.697: ISDN Se0/1/0:15 Q921: User RX <- RRp sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:11.697: ISDN Se0/1/0:15 Q921: User TX -> RRf sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:21.697: ISDN Se0/1/0:15 Q921: User TX -> RRp sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:21.701: ISDN Se0/1/0:15 Q921: User RX <- RRp sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:21.701: ISDN Se0/1/0:15 Q921: User TX -> RRf sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:21.705: ISDN Se0/1/0:15 Q921: User RX <- RRf sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:31.697: ISDN Se0/1/0:15 Q921: User RX <- RRp sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:31.697: ISDN Se0/1/0:15 Q921: User TX -> RRf sapi=0 tei=0 >>> nr=16 >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENT: UserIdle: callid 0x80B9 >>> received IS >>> DN_CALL (0x0) >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: UserIdle: Call to 2320635 >>> at 64 Kb >>> /s >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: isdn_get_guid: Cannot >>> allocate a G >>> UID (5) >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENT: process_pri_call: call id >>> 0x80B9, n >>> umber 2320635, Guid 0026F91065D9, speed 64, call type DATA, redial No, >>> CSM call >>> No, pdata No >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: process_pri_call: No name >>> in GTD >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: fill_cid_table_voice: Don't >>> know c >>> alling number for redial. >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: fill_cid_table_voice: >>> Created entr >>> y call_id 0x80B9, speed 64, remote 2320635, calling >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: Packet to CC Data >>> *Jul 22 09:05:41.433: 4D000180B91604030800101804000300 >>> *Jul 22 09:05:41.433: FF700900013233323036333504030800 >>> *Jul 22 09:05:41.433: 101803000300 >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: calltrkr_setup_received: >>> isdn_info >>> =1732177424l, call_id=0x80B9 ORIGINATE >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 EVENTd: calltrkr_setup_received: >>> calltrack >>> er disabled >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 Q931: Sending SETUP callref = >>> 0x0126 call >>> ID = 0x80B9 switch = primary-net5 interface = User >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 Q921: User TX -> INFO sapi=0 tei=0, >>> ns=16 >>> nr=16 >>> *Jul 22 09:05:41.433: ISDN Se0/1/0:15 Q931: SETUP pd = 8 callref = >>> 0x0126 >>> Bearer Capability i = 0x8890 >>> Standard = CCITT >>> Transfer Capability = Unrestricted Digital >>> Transfer Mode = Circuit >>> Transfer Rate = 64 kbit/s >>> Channel ID i = 0xA9839F >>> Exclusive, Channel 31 >>> Called Party Number i = 0x81, '2320635' >>> Plan:ISDN, Type:Unknown >>> *Jul 22 09:05:41.445: ISDN Se0/1/0:15 Q921: User RX <- RR sapi=0 tei=0 >>> nr=17 >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 Q921: User RX <- INFO sapi=0 tei=0, >>> ns=16 >>> nr=17 >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 Q931: RELEASE_COMP pd = 8 callref >>> = 0x812 >>> 6 >>> Cause i = 0x829F - Normal, unspecified >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 Q921: User TX -> RR sapi=0 tei=0 >>> nr=17 >>> *Jul 22 09:05:41.453: ISDN EVENTd: cc_clear_free_list freeing 0x673576E0 >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 EVENT: process_rxstate: ces/callid >>> 1/0x80B >>> 9 calltype 1 CALL_REJECTION >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 EVENTd: process_rxstate: cause=0x1F >>> (31), >>> cause_present=1 >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 EVENT: process_rxstate: ces/callid >>> 1/0x80B >>> 9 calltype 1 CALL_CLEARED >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 EVENTd: process_rxstate: cause=0x1F >>> (31), >>> cause_present=1 >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 EVENTd: calltrkr_call_cleared: >>> isdn_info=0 >>> x673EEE10, call_id=0x80B9 >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 EVENTd: isdn_report: callid 0x80B9 >>> *Jul 22 09:05:41.453: ISDN Se0/1/0:15 SERROR: isdn_report: Got a >>> disconnect on a >>> non-existent call id = 0x80B9. >>> This probably is a call that that was not answered 2 >>> HO-Rtr#show isd >>> HO-Rtr#show isdn status >>> Global ISDN Switchtype = primary-net5 >>> ISDN Serial0/1/0:15 interface >>> dsl 0, interface ISDN Switchtype = primary-net5 >>> Layer 1 Status: >>> ACTIVE >>> Layer 2 Status: >>> TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED >>> Layer 3 Status: >>> 0 Active Layer 3 Call(s) >>> Active dsl 0 CCBs = 0 >>> The Free Channel Mask: 0xFFFF7FFF >>> Number of L2 Discards = 0, L2 Session ID = 190 >>> Total Allocated ISDN CCBs = 0 >>> HO-Rtr#show is >>> HO-Rtr#show ishi >>> HO-Rtr#show isd >>> HO-Rtr#show isdn hi >>> HO-Rtr#show isdn history >>> >>> -------------------------------------------------------------------------------- >>> ISDN CALL HISTORY >>> >>> -------------------------------------------------------------------------------- >>> Call History contains all active calls, and a maximum of 100 inactive >>> calls. >>> Inactive call data will be retained for a maximum of 15 minutes. >>> >>> -------------------------------------------------------------------------------- >>> Call Calling Called Remote Seconds Seconds Seconds Charges >>> Type Number Number Name Used Left Idle >>> Units/Currency >>> >>> -------------------------------------------------------------------------------- >>> >>> -------------------------------------------------------------------------------- >>> HO-Rtr# >>> >>> >>> Please hint me anything .. >>> >>> Regards >>> >>> _______________________________________________ >>> For more information regarding industry leading CCIE Lab training, please >>> visit www.ipexpert.com >>> >>> >> > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
