Hello all, I'd like to get your thoughts on this, from all of you that have gone through this lab 1A initial config
I connect to proctorlabs with the ezvpn. i have the router, switch and phones I was trying to configure Lab 1A. i started my session this morning which is still active as of right now I waited 15 mins before I try to touch any device to avoid any kind of problems. when i finished configured the vlans and all of that on the 3 sites when i was getting ready to start the DHCP configuration I realized that i didn't have connectivity to the servers I did the recommended steps like resetting the vpn check the configuration on the ports however i did notice that switch port 1/0/24 was up up however nothing was configured the router didn't have any routing protocol running on the remote sites none of the pvcs were configured my question is. if there's nothing configured. no routing protocols no pvcs, etc should i need to configure the frame relay links ? enable routing to have connectivity to all the sites ? is that's the case that's cool, i didn't know and i know it may happen however i just reverted the pod, loaded the final configuration waitied 15 minutes at least and still I have no connectivity to the servers this time i reset the vpn again the configuarion on the ports has to be ok now reloaded my router reverted the pod again and still nothing this is a bit frustrating because i have spent most of my time trying to get connectivity to the servers. i have 5.5 hours on the pod left and i've spent 2 hours at least troubleshooting please let me know your thoughts this is my first experience and i don't know what to expect thank you
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com