There is not enough info here to troubleshoot this issue. Post full config of br1and pstn router and tell us what you have configured in cucm and what your goal is.
Your controller config is not matching your serial interface number. Controller 0/0/1 Serial interface 0/0/0 Reg, Jolicoeur wouter Sent from my iPad On Jan 6, 2011, at 22:24, Deepak sidana <sidana_dee...@yahoo.com> wrote: > Hi All, > > I am trying to connect the T1 from Br1-RTR to PSTN-WAN. Only when i use > service mgcp, under controller, layer 2 isdn staus as TEI_ASSIGNED. > > At PSTN-WAN Router, i am using "isdn protocol-emulate network" under s0/0/0:23 > > Branch1 Config:- > > BR1-RTR#sh isdn sta > Global ISDN Switchtype = primary-net5 > ISDN Serial0/0/0:23 interface > dsl 0, interface ISDN Switchtype = primary-net5 > Layer 1 Status: > ACTIVE > Layer 2 Status: > TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED > > ! > controller T1 0/0/1 > framing esf > linecode b8zs > cablelength long 0db > ! > interface Serial0/0/0:23 > no ip address > encapsulation hdlc > isdn switch-type primary-net5 > isdn bind-l3 ccm-manager > isdn incoming-voice voice > no cdp enable > > Please share you experince, if some one faced the same issue. > > Thanks&Rgds > Deepak Sidana. > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com