Hey Rynard , as you are using Cbarge , there is no need for Built in Bridge , you will need have the privacy off and the barge method as Cbarge from the phones pages , reset the phone and check the behavior ( make sure that you will have conf brigde available for the phones inside your MRGL
Ash On Mon, Sep 19, 2011 at 1:02 AM, Rynard Coetzee <rynard.coet...@bytes.co.za> wrote: > Hi > > I have issue to get cBarge to work when dialling in via my MVA number. When > I dial the MVA number and then start a new call to my HQ phone ,my Branch 2 > shows the Remote in Use ,but when I try to Cbarge into the call ,I just get > a fastbusy. I have Hardware conference bridge setup for both HQ and BR2 > phones ,any ideas what else the problem might be ? Also Built-in bridge and > Privacy have been set on both phones. > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com