Good news ... I was using IOS 12.4(24)T1 which was matching bug IOS Regards, Mohammed Al Baqari
Sent from my iPhone On Dec 2, 2011, at 8:06 PM, datucha123 datucha123 <datucha...@gmail.com> wrote: > I have tested it in my Lab, the the MoH was working without MTP either > through Xcoder or G729 enabled in IPVMS service. > > So that BUG does not effect my CUCM > > On Thu, Dec 1, 2011 at 10:13 PM, datucha123 datucha123 <datucha...@gmail.com> > wrote: > Great Post. Thanks you so much. > > I will test it in my LAB tomorrow and will post the results as well. > > Initially my issue was caused by the incorrect dspfarm profile for Xcoder. I > missed to put the G729r8 codec over there, so the Xcoder did not work, but as > soon as I have added that codec to Xcoder the MoH was transcoded :) > > But the BUG you have sent, is very intestring, so I will also test it > tomorrow. > > > On Thu, Dec 1, 2011 at 7:57 PM, Mohammed Al Baqari <baqari.voic...@gmail.com> > wrote: > I have tested this and got the result successful using MTP + XCODE. I used > exactly same scenario. Here is the output. > > > > HQ#sh call leg act su > > G<id> L<id> Elog A/O FAX T<sec> Codec type Peer Address > IP R<ip>:<udp> > > G0 L 83 N ORG T10 g729r8 VOIP P > 142.2.66.254:17734 > > G0 L 85 N ORG T4 g729r8 VOIP P > 142.2.64.254:17672 > > G0 L 86 N ORG T4 g729r8 VOIP P > 142.2.64.254:17502 > > G0 L 88 N ORG T4 g711ulaw VOIP P > 0.0.0.0:0 > > > > The interesting part is this. It wasn’t working without MTP (either I am > using g711 on MOH which needs XCODE or even if I change MOH to G729 which > doesn’t require XCODE). Finally I found that I am hitting this bug. So it’s a > must to use MTP over SIP trunk for MOH to work either with XCODE or not. > > > > CSCso85618 Bug Details > > > > Top of Form > > No Audio when Call is put on hold by remote party over Sip Trunk > > Symptoms: > > 1. The MOH does not work between CM and CME. > > 2. There is no audio on the CME endpoint when the remote CCM party resumes the > call on hold, conferences, or transfers with another CCM endpoint (scenario: > CME - CUBE - CCM). > > Conditions: Symptom 1 is observed if the phone registered to the CME is put on > hold by the CM, then the CME phone does not hear the MOH. > > Symptom 2 is observed if the CCM endpoint does a conference, hold, or > transfer. > > Workaround: Use an MTP. > > Regards, > > Mohammed Al Baqari > > > > From: ccie_voice-boun...@onlinestudylist.com > [mailto:ccie_voice-boun...@onlinestudylist.com] On Behalf Of datucha123 > datucha123 > Sent: Wednesday, November 30, 2011 10:59 PM > To: ccie_voice@onlinestudylist.com > Subject: [OSL | CCIE_Voice] Need Help with MoH > > > > Hello, > > > > I am facing a Problem with MoH over the SIP/H323 Trunk with MTP. > > > > I know, that the multicast MoH is not supported when the MTP is check in the > H323 gateway, but I have a problem with Unicast MoH with transcoding. > > > > But I have the following configuration. > > > > Only G711U is activated for MoH (default). > > > > I have a SIP Trunk towards CUCME, this SIP Trunk is in G729 Region, so that > this Region is using G729 to CUCM IP Phones, and to MoH regions as well: > > > > So I have > > HQ_Region - G711 Inside and G729 to SIP_Trunk_Region. > > SIP_Trunk_Region - G711 inside and G729 to HQ_Region. > > > > So the SIP Trunk is assigned the SIP_Trunk_Region (Through DP) and the IP > Phones along with the MoH Server are assigned the HQ_Region. > > > > Also I have an G729 MTP on a Router, which is assigned the MTP_Region (Which > is using G729 to all other Regions). > > Transcoder is assigne the HQ_Region. > > > > So when I call the SIP Trunk (CUCME IP Phones) the call is successful and > negotiated codec is G729, and MTP is also allocated, as I have checked the > MTP Required Checkbox. > > > > But when I press the Hold key on the CUCM IP Phone, the CUCME IP Phone hears > a Beeps instead of MoH Music. > > > > I cannot get how to make transcoder to transcode the MoH from G711 to G729, > so that the MTP will be also used on the SIP Trunk. > > > > BTW, when I remove the MTP Required from the SIP Trunk, the MoH is > transcoded, and the remote IP Phone (CUCME) can hear the music. > > > > But I want to have an MTP checked as well, and in this case the MoH music > does not play. (Only Beeps). > > > > Please help me. > > > > > > > > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com