What is the status of the voice ports on both ends of the call, are any of them hung up?
On Sun, Jun 10, 2012 at 6:34 PM, chase mergenthal <cm3_...@hotmail.com>wrote: > Any one know why I would be getting this? I already tried changing the > bchan selection order and get the same results... > > Jun 11 03:32:14.531: ISDN Se0/0/0:23 Q931: Applying typeplan for sw-type > 0xD is 0x0 0x0, Calling num +14087775002 > Jun 11 03:32:14.535: ISDN Se0/0/0:23 Q931: Applying typeplan for sw-type > 0xD is 0x0 0x0, Called num 911 > Jun 11 03:32:14.535: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8 callref = > 0x008A > Bearer Capability i = 0x8090A2 > Standard = CCITT > Transfer Capability = Speech > Transfer Mode = Circuit > Transfer Rate = 64 kbit/s > Channel ID i = 0xA98388 > Exclusive, Channel 8 > Calling Party Number i = 0x0081, '+14087775002' > Plan:Unknown, Type:Unknown > Called Party Number i = 0x80, '911' > Plan:Unknown, Type:Unknown > SiteA-RTR# > Jun 11 03:32:14.571: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8 callref > = 0x808A > Channel ID i = 0xA98388 > Exclusive, Channel 8 > Jun 11 03:32:14.579: ISDN Se0/0/0:23 Q931: RX <- ALERTING pd = 8 callref > = 0x808A > Progress Ind i = 0x8188 - In-band info or appropriate now available > Jun 11 03:32:14.619: ISDN Se0/0/0:23 Q931: TX -> DISCONNECT pd = 8 > callref = 0x008A > Cause i = 0x80AC - Requested circuit/channel not available > Jun 11 03:32:14.631: ISDN Se0/0/0:23 Q931: RX <- RELEASE pd = 8 callref = > 0x808A > Jun 11 03:32:14.635: ISDN Se0/0/0:23 Q931: TX -> RELEASE_COMP pd = 8 > callref = 0x008A > > > PRI config on PSTN RTR: > > controller T1 0/3/0 > framing esf > clock source internal > linecode b8zs > pri-group timeslots 1-8,24 > description ** T1 VOICE CONNECTION TO HQ-RTR ** > > > SiteA RTR > > no ip domain lookup > ! > multilink bundle-name authenticated > ! > isdn switch-type primary-ni > ! > voice-card 0 > no dspfarm > ! > ! > ! > voice service voip > allow-connections h323 to h323 > allow-connections h323 to sip > allow-connections sip to h323 > allow-connections sip to sip > ! > ! > ! > ! > ! > ! > ! > ! > ! > ! > ! > ! > ! > ! > voice translation-rule 1 > rule 1 /\(.*\)\(....\)/ /\2/ > ! > voice translation-rule 2 > rule 1 // /+/ > ! > ! > voice translation-profile DID > translate called 1 > ! > voice translation-profile E164 > translate calling 2 > ! > ! > ! > ! > ! > ! > archive > log config > hidekeys > ! > ! > ! > ! > controller T1 0/0/0 > framing esf > linecode b8zs > pri-group timeslots 1-8,24 > ! > controller T1 0/0/1 > framing esf > linecode b8zs > channel-group 0 timeslots 1-24 > description WAN CONNECTION- DO NOT CHANGE > ! > ! > ! > ! > ! > interface Loopback0 > ip address 10.10.110.1 255.255.255.255 > h323-gateway voip interface > h323-gateway voip bind srcaddr 10.10.110.1 > ! > interface FastEthernet0/0 > no ip address > duplex full > speed 100 > ! > interface FastEthernet0/0.101 > encapsulation dot1Q 10 > ip address 10.10.100.1 255.255.255.0 > ! > interface FastEthernet0/0.102 > encapsulation dot1Q 20 > ip address 10.10.200.3 255.255.255.0 > ip helper-address 10.10.210.10 > ! > interface FastEthernet0/0.103 > encapsulation dot1Q 30 > ip address 10.10.210.1 255.255.255.0 > ! > interface FastEthernet0/1 > no ip address > shutdown > duplex auto > speed auto > ! > interface Serial0/0/0:23 > no ip address > encapsulation hdlc > isdn switch-type primary-ni > isdn incoming-voice voice > no cdp enable > ! > interface Serial0/0/1:0 > no ip address > encapsulation frame-relay > frame-relay lmi-type ansi > ! > interface Serial0/0/1:0.1 point-to-point > ip address 10.10.111.1 255.255.255.0 > ip ospf mtu-ignore > snmp trap link-status > frame-relay interface-dlci 201 > ! > interface Serial0/0/1:0.2 point-to-point > ip address 10.10.112.1 255.255.255.0 > ip ospf mtu-ignore > snmp trap link-status > frame-relay interface-dlci 202 > ! > router ospf 1 > router-id 10.10.100.1 > log-adjacency-changes > network 10.10.0.0 0.0.255.255 area 0 > ! > ip forward-protocol nd > ! > ! > ip http server > no ip http secure-server > ! > ! > ! > ! > ! > ! > ! > control-plane > ! > ! > ! > voice-port 0/0/0:23 > ! > ! > ! > ! > ! > dial-peer voice 1 pots > translation-profile incoming DID > incoming called-number . > direct-inward-dial > ! > dial-peer voice 21010 voip > preference 2 > destination-pattern 5... > session target ipv4:10.10.210.10 > dtmf-relay rtp-nte > codec g711ulaw > no vad > ! > dial-peer voice 21011 voip > preference 1 > destination-pattern 5... > session target ipv4:10.10.210.11 > dtmf-relay rtp-nte > codec g711ulaw > no vad > ! > dial-peer voice 911 pots > translation-profile outgoing E164 > destination-pattern 911 > port 0/0/0:23 > prefix 911 > > > -Chase > > ------------------------------------------------------------------------------------------------------ > If winners never quit and quitters never win, then who coined the phrase, > "Quit while you’re still ahead."? > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
