Ramcharan, I have never tried AVT so I will leave that one alone. For MWI I would recommend using MWI Subscribe. If you need that config let me know. I did test outcalling once and it took a while for me to get it to work. I eventually did a debug ccsip messages and saw that CUE was using a different number for outcalling. You have 4010.... and 4011.... for mwi on and off. Turn on your debug and leave a message and I am pretty sure CUE is not calling 4011.... and you will have to replace your ephone-dn with something different to match. I am not sure if the first 4 digits are configurable in CUE or not but it did not honor my first 4 digits... it picked its own. Also get rid of your MWI dial-peers. They are not needed. Just the ephone dns.
-----Original Message----- From: ccie_voice-boun...@onlinestudylist.com [mailto:ccie_voice-boun...@onlinestudylist.com] On Behalf Of Ramcharan Arya Sent: Thursday, October 25, 2012 5:18 PM To: ccie_voice@onlinestudylist.com Subject: [OSL | CCIE_Voice] Unable to call AVT from PSTN 911 Hello, I am working on a task trying to call AVT extension 4005 from PSTN 911. I am able to call voice mail and auto-attendent but when I call AVT number I get re-order tone. Has anyone try AVT setup on CUE. Please let me know. I got another problem with MWI lamp is not working when use left voice mail to extension. telephony-service no auto-reg-ephone max-ephones 52 max-dn 192 ip source-address 10.10.128.1 port 2000 voicemail 4004 max-conferences 8 gain -6 moh music-on-hold.au multicast moh 239.23.4.10 port 2000 web admin system name Admin password admin dn-webedit time-webedit transfer-system full-consult ! ephone-dn 98 number 4010.... mwi off ! ! ephone-dn 99 number 4011.... mwi on ! dial-peer voice 98 voip description MWI OFF incoming called-number 4010.... codec g711ulaw no vad ! dial-peer voice 99 voip description MWI ON incoming called-number 4011.... codec g711ulaw no vad ! dial-peer voice 4004 voip destination-pattern 4004 session protocol sipv2 session target ipv4:10.10.128.2 dtmf-relay sip-notify codec g711ulaw no vad ! dial-peer voice 4005 voip ** Description AVT *** destination-pattern 4005 session protocol sipv2 session target ipv4:10.10.128.2 dtmf-relay sip-notify codec g711ulaw no vad Can you please suggest is something is missing in my configuration. Thanks & Regards, Ramcharan Arya _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
