Dears, So the above access list is correct ?? CUE signaling traffic only used this port ? 2748 Is there any document showed the used port for the CUE traffic ??
On Thu, Apr 18, 2013 at 12:46 AM, Jack Kamina <kamina.j...@yahoo.com> wrote: > on one of the practice lab the need is to police the signaling packets to > and from CUE inbound into the HQ switch to 32 kbps and then remark the DSCP > to 0. I built up the config below but dont see any packets matched on the > show policy-map interface command. CUE IP is 10.1.6.253 . CUCM IP is > 10.10.210.10 (pub) and 10.10.210.11 (sub) .....is the access list built > correctly? > > access-list 110 permit tcp host *10.1.6.253* any eq 2748 > > ! > > class-map match-all CUE-SIGNAL > > match access-group 110 > > ! > > policy-map CUEMAP > > class cti-qbe > > set dscp af31 > > bandwidth 20 > > ! > > interface Fa0/1/0 > > description HQ-ROUTER-INTERFACE > > service-policy input CUEMAP > > > mls > qos > mls qos map cos 0 8 16 24 32 46 48 56 > mls qos map policed-dscp 24 26 to 8 > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
