Hello everyone,
I connected my CUCM with my CME using H.323 gateway. I am facing a little bit
challenge i can dial from CUCM to CME but i can't dial from CME to CUCM. I am
using 4 digits dialing between both sites on the call manager i created RG
using the H.323 gateway i created in the callmanager a RL pointing to gateway
and a RP using that RL i also created DP,Region,LOC, etc...
On the CUCM my RP looks like this:
6.XXXX with a predot
On the gateway incoming calls is set to 4
When dial 6 + last 4 digits extension on the CME the phone rings.
The challenge is that we have one HQ with and two remote sites all of them
under on cluster one PUB and two SUBs the HQ and one remote site register with
SUB1 as primary, SUB2 secondary and PUB last the other remote site register
with SUB2 as pri, SUB1 as sec and PUB last all three site have different DNs
and different area code.
HQ last 4 digits start with 7
Remote 1 DNs start with 0
Remote 2 DNs start with 2,4,5,8 and also has two separate area code
my configuration on the CME looks like this:
This dial-peer go to HQ and Remote 1
dial-peer voice 2000 voip
description calls to HQ and Remote 1
destination-pattern ^[0,7]...$
session target ipv4:100.260.129.21
dtmf-relay h245-alphanumeric
no vad
This dial-peer go to Remote 2
dial-peer voice 3000 voip
description calls to Remote 2
destination-pattern ^[2,4,5,8]...$
session target ipv4:100.260.152.20
dtmf-relay h245-alphanumeric
no vad
When someone call from CME to CUCM the calls die. i am not using any
translation pattern i think i don't need one
Any idea what i am missing here ?
Thanks,
Ben
_______________________________________________
Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos ::
iPexpert on YouTube: www.youtube.com/ipexpertinc
