Hi,
I just found out, that this effect just occurs when I push the "twin
refine" button. I have 4 slightly twinned datasets, and so far the twin
refine worked very well...but this should not happen, I think.
Any explanations or advise?
greetings,
Christian
Hi ccp4bb,
I have a big problem concerning refmac_5.5.0088. I refined a couple of
structures. Now after refining I realized that refmac sets wrong
resolution limits for my data. Scaling was done with scala. I cut the
data at 1.8 A. Then I used molrep; respectively difference fourier.
Later in refmac I set 1.8A as resolution limit as well. But in the
logfile and in the output-pdb-file there is 1.64A written as resolution
limit. In addition the completeness is 80% instead of 98. With my other
datasets refmac behaves similar (1.87 instead of 2.1, ...). What do I
have to do that refmac applies and doesn?t change my settings?
Thanks in advance for any advise,
Christian
