> > From: tony duell > > > I find [RL0x's] easier than RK05s
> Try taking out an RA81! I did an R80 (not much lighter) single-handedly. The trick with those is to take the HDA out. It takes only a few minutes. Raise the logic chassis (top part of the case including the front panel), then lock the heads (you MUST do this anyway), release the belt tension (lever at the front right), then unplug 3 cables (2 small ones on the front of the HDA and a 40 way ribbon from the PCB on top), take off the 4 mouting nuts and lift the HDA up and out. Then tape the spindle pulley so it doesn't turn when moving the unit. If it turns backwards it is likely to damage the heads. The rest of the drive (chassis, PSU, motor, logic PCBs) is just about liftable fully assembled. I think the worst is the RA60. It's very heavy and it is a pain to dismantle. You have to take it apart a little bit at a time. -tony