I did not know that. It must have been a fairly rare thing? I don't think I've ever seen one photographed.
Best, Sean On Sun, Aug 9, 2015 at 6:06 PM, Pete Turnbull <p...@dunnington.plus.com> wrote: > On 09/08/2015 18:14, Sean Caron wrote: > >> DEC did sell a version of the BA23 that was intended to be used just as an >> expansion peripherals cabinet. You shouldn't have any problems putting HH >> devices in BA23 bays (so long as you have the appropriate interfaces to >> drive them) but you may need i.e. 3.5" to 5.25" bracket to attach to the >> BA23 sleds, and you'll have (cosmetic) blank space on top after putting a >> HH device in a FH bay. I imagine you'd have to make a special bracket to >> mount a TZ30/RX33 over-under in one of the 5.25" bays in the BA23 but it >> could certainly be done ... No such factory configuration exists AFAIK >> > > If a TZ30 has the same mounting holes as a 5.25" disk drive, it's doable. > There's an official DEC mounting kit to mount 2 x RX33 where you'd normally > find an RX50 in a BA23/BA123. It's basically two side plates, to hold the > upper and lower drives together. > > -- > Pete > > Pete Turnbull >