i got a few of them and have the data somewhere i will try to dig it up and send u off list
On 8/21/2015 5:33 PM, Billy Pettit wrote: > I have a small batch of Data I/O EPROM burners. Trying to test them out and > ran into a nightmare. They require a pin family and size parameter. But in > none of the documentation is there any mention of what these values are. > There are some generic pinouts, which are almost useless because Data I/O > changed the definition of several pins. > > Then the manual says to get your part's timing chart and compare them to 409 > pages of timing charts to find the family type! Nothing is mentioned > anywhere on how to calculate size parameter. > > There should be a chart or document somewhere that gives the parameters by > model numbers like 2516, 2764, etc. > > Anyone know of a document like this? > > Anyone have experience with the model 29A&B, Model 19, Model 100 gang > programmer, etc. > > At this point, without better data, these 11 -12 deveces are heading for the > scrap pile. This is the poorest documentation I've ever seen on a piece of > test equipment. > > Billy Pettit > > -- The contents of this e-mail and any attachments are intended solely for the use of the named addressee(s) and may contain confidential and/or privileged information. Any unauthorized use, copying, disclosure, or distribution of the contents of this e-mail is strictly prohibited by the sender and may be unlawful. If you are not the intended recipient, please notify the sender immediately and delete this e-mail.
