> On Mar 29, 2016, at 8:18 PM, Guy Sotomayor <g...@shiresoft.com> wrote:
>
> I just finished laying out the board for the MEM11A. The last roadblock was
> figuring out
> where the last 3 unrouted wires were. EagleCAD didn’t make it easy to find
> them and I
> haven’t quite figured out how to use the autorouter on Eagle 7.5, so I did
> this all by “hand”
> (at just under 2000 wires it took a while).
I can imagine. Hand-routing tends to produce much better results; the
autorouter in EagleCAD isn't all that good. A simple way to find the not yet
routed wires is to turn off the metal layers but leave the "ratsnest" layer
visible.
paul
