> On Nov 8, 2016, at 12:08 PM, Guy Sotomayor Jr <g...@shiresoft.com> wrote:
>
>
>> On Nov 8, 2016, at 8:47 AM, Jon Elson <el...@pico-systems.com> wrote:
>>
>> On 11/07/2016 10:31 PM, Jon Elson wrote:
>>> On 11/07/2016 07:59 PM, Mark Linimon wrote:
>>>> On Mon, Nov 07, 2016 at 11:23:58AM -0800, Chuck Guzis wrote:
>>>>> But if you're a suburban resident living on Mulberry Street, anything
>>>>> but single-phase is pretty much out of the question.
>>>> Oh, you can get it -- but be prepared for a large hassle.
>>>>
>>>> A former neighbor had a 440V 3-phase Italian lathe in his backyard shop,
>>>> among other toys. After he was laid off from his aerospace job doing
>>>> machining it was how he made his living. He was a very handy person
>>>> to know :-)
>>>>
>>>> mcl
>>>>
>>> I have two 3-phase machines in my shop (Bridgeport mill and Sheldon lathe)
>>> and run them each off a properly-sized VFD. 2-phase in, 3-phase out, plus
>>> variable speed and dynamic braking.
>>>
>>> Jon
>>>
>> And, of course, that is really SINGLE-PHASE power on 2 wires, just to save
>> anybody the trouble of correcting my error.
>>
>
> I’m looking to have to do something to get 3-phase for the IBM 4331 gear. I
> haven’t quite added up the power requirements yet but I’m guessing its going
> to be in the 10-15kVA range. Since the power to all of the gear is really
> split between 3 loads (string of 4 3340 drives, 3803 control unit + 2 3420
> tape drives and 2821 control uint + 1403 printer + 2540 card reader/punch) I
> need to figure out if it’s best to have one big converter or 3 smaller ones.
> It’s unlikely that I’d be running all of the peripherals at once. The 4331
> itself runs off of single phase 220v.
A VFD is a good option and may be quite economical if you get one of the low
cost simple ones. I have one (3 hp model for my lathe) that cost only a bit
over $100, though the price has gone up since. (Westinghouse TECO brand.)
VFDs specified for single phase input tend to stop around 3 hp, as far as I
have seen. Rumor has it that higher power units will also work (possibly with
some derating) even though they claim to be 3 phase input, when you feed them
just one phase on 2 of the 3 wires. I haven't tried that (but it matches how
my VFD is connected).
The other option is a "rotary converter". Basically that's a 3 phase motor
connected to one phase power (with a start and run capacitor); it generates the
missing phase roughtly in dynamotor fashion. Those can be built (articles on
the web) or bought from machinery supply companies such as Enco; they show
models up to 20 hp, i.e., about 15 kW. When I was looking into converters, I
found VFDs to be the less expensive option. The instant reverse and variable
frequency features were also attractive for lathe use; for powering computers
that would not apply. Well, not unless you need 400 Hz for your Cyber 6600 --
in which case you'd need to check the VFD will go that high, not all do.
Given that you have a number of smaller devices and that not all might need to
run, several smaller converters sounds like a good option, especially if that
gets you into the "economy VFD" range.
paul
