Ethan Dicks <ethan.di...@gmail.com> wrote:
I don't happen to have a VR201 here right now to measure directly (or I would just do that), but IIRC, there's a threaded mounting insert on the bottom (for the "E.T. Stand", if nothing else), I want to fabricate a shelf clip for a VR201 and am seeking the diameter/thread pitch for the insert. Does anyone have that info handy? It's likely larger than 1/4-20 from what I remember.
There are four brass inserts in a trapezoidal pattern, each threaded 1/4-20 (National Coarse). The trapezoid is 7.0" center-to-center for the two nearest the screen, and the rear ones are 5.0" center-to-center. It is 5.0" between the front (screen) pair and the rear pair. This is for a VR201-B -- other dash-variants may be different. If there is a base with a single large threaded insert, it may be an adapter that goes between the VR201 and the stand. Now, could someone please tell me the pinouts for the 15-pin connector? I would like to use it to view RS-170 video, if possible. Alan Frisbie