On 5/28/2019 6:42 AM, William Donzelli wrote:
I think that is an IBM specific knob. I will keep an eye out for one,
but do not hold your breath! It is certainly not a common knob.
Is it for a 1/4 inch shaft?
--
Will
Yes, it's a standard 1/4" shaft. Might try and get one 3D printed if I
can figure out how to draw it.
Bob
On Mon, May 27, 2019 at 11:41 PM Bob Rosenbloom via cctalk
<cctalk@classiccmp.org> wrote:
A long shot I know, but I'm looking for an IBM knob that's missing from
a 609 calculator panel I have.
Photos can be seen here:
http://dvq.com/ibm/ibm-609-pnl1.JPG
http://dvq.com/ibm/ibm-609-pnl4.JPG
http://dvq.com/ibm/ibm-609-pnl5.JPG
I have no idea if the knob was made by IBM or was a common knob of the
times.
Thanks,
Bob
--
Vintage computers and electronics
www.dvq.com
www.tekmuseum.com
www.decmuseum.org
--
Vintage computers and electronics
www.dvq.com
www.tekmuseum.com
www.decmuseum.org
