> From: Douglas Taylor > I'm putting together a MicroPDP-11/23 in a BA23 box. Have the M8189 CPU > quad width board and the bulkhead cabinet kit .. how the cabling goes > from the M8189 CPU board to the bulkhead cabinet kit?
I _think_ this might be the cable you need: https://www.ebay.com/itm/CK-KDF11-CABLE-ONLY-P-N-70-20451-1C/151622708242 but I'm not familiar with the cab kit, so I'm not sure. > The 10 pin connectors on the CPU board don't seem to be keyed ... > Is there something that gives the orientation away? These 10 pin EIA connectors (same in the DLV11-J, KDJ11-B, etc) are keyed, with a missing pin. DEC cables for these connectors have a plug in the matching hole. > From: Glen Slick > In the photos that I have found of the M8189 console panel there is a > '1' just above the top right of the 20-pin connector indicating Pin 1. > A trace can be seen leading from that pin to the baud rate circuitry. > So that pin would go to Pin 1 of one of the 10-pin connectors on the M8189. Y'all love to re-invent the wheel, I see: http://gunkies.org/wiki/DEC_asynchronous_serial_line_pinout#10_pin_header I should check to see if the KDJ11-B has the same external baud rate selection support, and if so, update the page to add it. Oh, that's the other way to tell the orientation, with non-flat-cable cables; with the loopback jumper on pins 7&9. Noel