On 5/1/20 4:19 PM, Chuck Guzis via cctalk wrote:
On 5/1/20 1:59 PM, Curious Marc via cctalk wrote:
Agreed. They sure are pressed in, then riveted in for good measure. You’d have
to drill them out first. Not an easy modification.
Marc
PTFE 2mm ID 3mm OD tubing is a standard size. That might fit.
--Chuck
All of the QIC-24 cartridges sitting next to me right now have posts
that are machined with 1-2mm deep tape guides. I don't see how to
install tubing over the posts and have the guides still do their job.
As I noted, I have tried isopropyl alcohol to clean them off but they
still stick. Is this something that baking will help with? Maybe using
acetone instead of alcohol to wipe the posts down as well?
alan
