On Thu, Aug 20, 2020 at 04:38:49PM +1000, Steve Malikoff via cctalk wrote: [...] > I had a thought, that if the pin spacing was on par with say a common 15-pin > VGA male connector I could buy a bunch of dirt cheap Golden Dragon ones, set > them up in the mill and run a high speed slitting saw diagonally between the > pins (right though the block and metal surround in one go), and just add a > plastic spacer to bump it out to the length of the 19-pin. After all there > are only 6 pins used, and of those, just one (assuming common) that would be > on the extended bit.
Cutting-down a DA-26 might be a better bet, and they're only pennies more expensive than the DA-15 VGA connector.