my distro is debian 2.2r3 burner philips cdd2600 cdrecord ver 1.8 i loaded from cdrom (ide) the audio tracks by cdda2wav into an empty dir in hdb3 i can listen to them via xmms afterward, as per examples in man cdrecord i launched: cdrecord -v dev=4,0 -dao -useinfo *.wav
but.....it did not work : herebelow is the error output: ..... ATIP info from disk: Is not unrestricted Disk application code: 0 ATIP start of lead in: -11839 (97:24/11) ATIP start of lead out: 359849 (79:59/74) Disk type: Long strategy type (Cyanine, AZO or similar) Manuf. index: 24 Manufacturer: SONY Corporation cdrecord: Warning: controller returns zero sized Speed/Dummy information page. cdrecord: Warning: controller returns wrong size for Speed/Dummy information page. cdrecord: Warning: controller returns wrong page 0 for Speed/Dummy information page (23). Blocks total: 359849 Blocks current: 359849 Blocks remaining: 23292 Starting to write CD/DVD at speed 1 in write mode for single session. Last chance to quit, starting real write in 1 seconds. Waiting for reader process to fill input buffer ... input buffer ready. Sending CUE sheet... cdrecord: SAO writing not available or not implemented for this drive. cdrecord: Cannot send CUE sheet. cdrecord: fifo had 128 puts and 0 gets. cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%. .............. obviously i am worried about the three warnings concerning speed/dummy and the fact that that cdrecord cannot send the cue sheet. as for the sao problem ........ i do not even know what is sao :-( further information: i launched 'cdrecord -scanbus' and it reports that my philips is on 0,4,0 then i tried 'less /proc/scsi/scsi' and i get the same result (0,4,0 philips cdd2600 rev 1.07) obviously, for this kind of operations, i login as root; mount point of /dev/sr0 (link to /dev/scd0) is /burner and if i insert a data cd in the burner and do #mount /burner and then #ls /burner i get the list of files in the cd. i have a scsi isa card advansys (i do not remember the model), to which the burner only is connected, which is correctly listed in dmesg. the burner, under win, works perfectly :-/ thanks for your help aldo -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]