On 09/17/2015 03:53 AM, mark wrote:
Really? In Centos 6, if I do an init 3, it shuts down X; none of the above did that,
You ran "systemctl start multi-user" when you meant to "systemctl isolate multi-user".
The man page describes isolate: "This is similar to changing the runlevel in a traditional init system."
Aside from the fact that you use the same command, systemctl, to "start" a service and "isolate" a runlevel, none of the problems you described had anything to do with systemd.
In fact, even switching runlevels/targets is unrelated to the video modules. You always have to blacklist the video driver, or boot with "nomodeset" to remove the video card's kernel module (Actually, you might be able to "echo 0000:<pci ID>" > /sys/bus/pci/devices/0000:<pci ID>/driver/unbind" sometimes. Some drivers might cause a kernel panic, though.) because even in multi-user mode with no X.org, the kernel is still using the module for its console.
_______________________________________________ CentOS mailing list CentOS@centos.org https://lists.centos.org/mailman/listinfo/centos
