> -----Original Message----- > From: centos-boun...@centos.org [mailto:centos-boun...@centos.org] On > Behalf Of Gordon Messmer > Sent: Friday, September 30, 2016 1:01 AM > To: CentOS mailing list > Subject: Re: [CentOS] Virtualization Networking > > On 09/29/2016 07:54 PM, TE Dukes wrote: > > For whatever reason, the default NAT setup no longer works. > > Start over with a new install. Record each change you make, carefully. > > > I got some kind > > of bridge network (mactap) setup that has access to the outside but I > > still can't connect locally. > > > As I noted, when using the macvtap, the host and guest can't communicate > unless you enable hairpin mode. >
I read something about turning off and disabling NetworkManager. I haven't done this. I'm getting ready to throw in the towel. If I can't set this up to at least access the VM from the LAN, I can't test CentOS 7 and the software I want to run. It makes it very hard to setup and configure with vi. Thanks! _______________________________________________ CentOS mailing list CentOS@centos.org https://lists.centos.org/mailman/listinfo/centos
