Hi,
I added the following to /etc/sysctl.conf:
net.ipv4.ip_forward = 1
sysctl -p does not show any errors.
So after a #service network restart, I see this:
Shutting down interface eth0: [ OK ]
Shutting down loopback interface: [ OK ]
Disabling IPv4 packet forwarding: net.ipv4.ip_forward = 0
[ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
Bringing up interface eth1:
Determining IP information for eth1... done.
But a sysctl -p shows the right info after? Is this behavior normal?
I have seen the same thing. I think what is happening is that when you
restart networking, it disables packet forwarding. When you start it, it
will re-enable. After you start the network type:
"/sbin/sysctl net.ipv4.ip_forward"
I expect that you will see "net.ipv4.ip_forward = 1"
Please confirm.
Barry
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
