Hi,
I try to set up
- A centos 6 firewall
- With proxy-arp (I know: arp is not supported in ipv6)
with ipv6.
Arp does not exist for ipv6. So I have added:
sysctl -w net.ipv6.conf.default.proxy_ndp=1
To use the neighbor proxy facility.
How to activate ipv6 forwarding? As far as I have found, this changed in RHEL6
from 6.1 (/etc/sysconfig/network) to 6.2 (/etc/sysctl.conf). CentOS 6?
So I have used
sysctl -w net.ipv6.conf.all.forwarding=1 as in RHEL 6.2
As in ipv4 I would prefer to proxy the clients behind the firewall.
eth0 is WAN, eth1 is LAN.
I have read to use
ip -6 neigh add proxy <ipv6 address of eth1> dev eth0
but
ip -6 neigh show
shows nothing.
Then I have tried
Ip -6 neigh add proxy <ipv6 address of client> dev eth0
Same result.
Is there any How To for ipv6 routing and proxying for CentOS?
Best regards
Helmut
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
