On Jan 22, 2012, at 4:41 PM, Ross Walker <rswwal...@gmail.com> wrote:
> On Jan 22, 2012, at 10:00 AM, Boris Epstein <borepst...@gmail.com> wrote: > >> Jan 22 09:17:53 nrims-bs kernel: 3w-9xxx: scsi6: AEN: ERROR (0x04:0x0026): >> Drive ECC error reported:port=4, unit=0. >> Jan 22 09:17:53 nrims-bs kernel: 3w-9xxx: scsi6: AEN: ERROR (0x04:0x002D): >> Source drive error occurred:port=4, unit=0. >> Jan 22 09:17:53 nrims-bs kernel: 3w-9xxx: scsi6: AEN: ERROR (0x04:0x0004): >> Rebuild failed:unit=0. >> Jan 22 09:17:53 nrims-bs kernel: 3w-9xxx: scsi6: AEN: INFO (0x04:0x003B): >> Rebuild paused:unit=0. > > From 3ware's site: > 004h Rebuild failed > > The 3ware RAID controller was unable to complete a rebuild operation. This > error can be caused by drive errors on either the source or the destination > of the rebuild. However, due to ATA drives' ability to reallocate sectors on > write errors, the rebuild failure is most likely caused by the source drive > of the rebuild detecting some sort of read error. The default operation of > the 3ware RAID controller is to abort a rebuild if an error is encountered. > If it is desired to continue on error, you can set the Continue on Source > Error During Rebuild policy for the unit on the Controller Settings page in > 3DM. > > 026h Drive ECC error reported > > This AEN may be sent when a drive returns the ECC error response to an 3ware > RAID controller command. The AEN may or may not be associated with a host > command. Internal operations such as Background Media Scan post this AEN > whenever drive ECC errors are detected. > > Drive ECC errors are an indication of a problem with grown defects on a > particular drive. For redundant arrays, this typically means that dynamic > sector repair would be invoked (see AEN 023h). For non-redundant arrays > (JBOD, RAID 0 and degraded arrays), drive ECC errors result in the 3ware RAID > controller returning failed status to the associated host command. > > Sounds awfully like a hardware error on one of the drives. Replace the failed > drive and try rebuilding. > This error code does not bode well. 02Dh Source drive error occurred If an error is encountered during a rebuild operation, this AEN is generated if the error was on a source drive of the rebuild. Knowing if the error occurred on the source or the destination of the rebuild is useful for troubleshooting. It's possible the whole RAID6 is corrupt. -Ross _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
