Hi digimer, Sorry, I made a mistake. "... After rebooting centos generates a device called /dev/et0. ..." should be "... After rebooting centos generates a device called /dev/eth0. ..."
CentOS made it. I got what I want. Where is the general guide? I didn't understood what you mean. > -----Ursprüngliche Nachricht----- > Von: Digimer [mailto:li...@alteeve.ca] > Gesendet: Donnerstag, 27. September 2012 07:27 > An: CentOS mailing list > Cc: KNOPS Manfred > Betreff: Re: [CentOS] rename network card device /dev/p3p2 to /dev/eth0 > > Check for a typo where you got the 'et0', that's not a normal name (emX, > ethX, pXpY and wlanX are the usual). > > As for a general comment/guide; make sure you've updated the > /etc/sysconfig/network-scripts/ifcfg-X files (note the DEVICE="..." and > HWADDR="..." lines). > > Here's a general guide for renaming devices under EL6 (inc. CentOS 6.3, > which I rename NICs under often without trouble). > (...) Mit freundlichen Grussen / Best Regards / Cordialement, Manfred KNOPS This email and any attachments are intended solely for the use of the individual or entity to whom it is addressed and may be confidential and/or privileged. If you are not one of the named recipients or have received this email in error, (i) you should not read, disclose, or copy it, (ii) please notify sender of your receipt by reply email and delete this email and all attachments, (iii) Dassault Systemes does not accept or assume any liability or responsibility for any use of or reliance on this email. For other languages, go to http://www.3ds.com/terms/email-disclaimer _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos