Dave, Nice!
I am adapting my CeroWrtScripts to OpenWrt. It still uses standard OpenWrt firewall/bridging/etc. See config-openwrt.sh in https://github.com/richb-hanover/OpenWrtScripts. So far, it has sections for: - setting the WAN credentials, - updating the opkg repository and loading special packages, - setting the root password, - setting time zone, - enabling SNMP and mDNS on the LAN, - and, of course, configuring SQM to a desired state. Rich On May 5, 2015, at 4:50 AM, Dave Taht <[email protected]> wrote: > get it from: http://snapon.lab.bufferbloat.net/~cero3/cake/ar71xx/ > > Not tested on the 3800 yet, only tested on the archer c7v2. I am about > to make my gf's main link run this to see what happens... > > * General notes > ** This is NOT cerowrt. Device naming is std openrt, firewall std > openwrt, bridged wifi/ethnet, etc. This is basically an attempt at > testing cake, dnssec, etc. > ** Unlike the openwrt chaos calmer nightlies this has the gui pre-installed > (note that it has both the ssl and non ssl version for no reason I > can figure out) > ** babel is installed but not enabled on any interface > ** numerous other limitations > > * archer notes > ** You need to opkg update; opkg install kmod-ath10k # and reboot > (then configure the wifi interfaces as desired) > ** sqm defaults to the wrong wan interface for this device > ** ath10k does not seem to have working adhoc support (thus no babel over > 5ghz) > > > > -- > Dave Täht > Open Networking needs **Open Source Hardware** > > https://plus.google.com/u/0/+EricRaymond/posts/JqxCe2pFr67 > _______________________________________________ > Cerowrt-devel mailing list > [email protected] > https://lists.bufferbloat.net/listinfo/cerowrt-devel _______________________________________________ Cerowrt-devel mailing list [email protected] https://lists.bufferbloat.net/listinfo/cerowrt-devel
