Hi Jim,
On Jun 23, 2015, at 04:41 , Jim Reisert AD1C <[email protected]> wrote: > On Fri, Jun 19, 2015 at 3:24 PM, Dave Taht wrote: > >> Fresh bits! Get your fresh bits here! (totally untested) >> http://snapon.lab.bufferbloat.net/~cero3/lupin/ar71xx/ > > I installed the factory image on a WNDR3800 and all came up as it > should. WINS networking is working, both Dish Network and Sony > blu-ray players have wireless Internet access. > > Are the "out-of-the-box" settings for SQM acceptable for Comcast (60 > Mbs down/6 Mbs up)? Most likely not. Check http://wiki.openwrt.org/doc/howto/sqm . Rich published a great set of instructions for setting up sqm-scripts under openwrt proper. > Should I check the "Enable" box on the SQM "Basic Settings" tab? You certain should if you want it to be active, make sure though, to at least select the correct interface and put in rates for the shaper below your link rates, so probably 56Mbps for downlink and 5.7Mbps for uplink as first approximation. > Should I change any settings on the "Queue Discipline" tab? You need to select the qos script of your choice, simple.qos if you want to have three priority tiers, simplest.qos if you do not. Best Regards Sebastian > > Thanks - Jim > > -- > Jim Reisert AD1C, <[email protected]>, http://www.ad1c.us > _______________________________________________ > Cerowrt-devel mailing list > [email protected] > https://lists.bufferbloat.net/listinfo/cerowrt-devel _______________________________________________ Cerowrt-devel mailing list [email protected] https://lists.bufferbloat.net/listinfo/cerowrt-devel
