On Fri, Oct 23, 2015 at 9:10 AM, Richard Smith <smithb...@gmail.com> wrote:
> I have a shiny new Linksys WRT1900ACS to test. > > I thought it might be nice to start with some comparisons of factory > firmware vs OpenWRT with sqm enabled. > Here are my results with the same router (unless the WRT1900ACS is different from the WRT1900AC): http://burntchrome.blogspot.com/2015/06/sqmscripts-before-and-after-at-160mbps.html > So I built and installed an openwrt trunk but the results were very > non-impressive. Rrul test reported mulit-seconds of latency and it was > equally non-impressive with sqm enabled or disabled. So I assumed that sqm > in trunk on this device must not work yet. Then I wondered how well sqm in > trunk was tested and that perhaps its broken for all devices. > Trunk or the Chaos Calmer release? (I"m running CC RC1) > My test setup: > > Laptop<--1000BaseT-->DUT<--1000baseT-->Server > Which ports on the DUT were you using? are those local ports, or is one of those the "internet" port? -Aaron
_______________________________________________ Cerowrt-devel mailing list Cerowrt-devel@lists.bufferbloat.net https://lists.bufferbloat.net/listinfo/cerowrt-devel