Replies to this message are sent to The Chevelle Mailing List
------------------------------------------------------------
pprof
Its beeen a long time, but this should get you started. Hopefully
someone who has more experience than I will tell us both where I am wrong
:).
1-Make sure tranny is in neutral.
2- There should bushings where the linkage goes into the shifter and
tranny arms - make sure that they are present and not worn. Replace if
necessary.
3-Also check the linkage arm ends for wear.
2-there are holes in the shifter arms at the bottom of the handle- put a
bolt or screwdriver that is about the same diameter (5/16???) thru all 3
shifter arms. You may have to disconnect one or more of the linkage arms
to get it thru all 3.
4-adjust the fitting at the end of the shifter linkage till they fit in
the tranny arms with the shifter arms "Pinned".
That should do it.
And again - hopefully someone will update this with some curent info.
rick schaefer
http://members.home.net/jimmy4/rick1972elky.htm
http://chevelles.com/showroom/ricks%20motor%20-L
-----Original Message-----
From: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Date: Fri Jun 29 05:56:43 PDT 2001
Subject: [Chevelle-List] Muncie shifter 1967 Chevelle
>I am having problems with my new shifter in a 1967 Chevelle SS 396
>convertible. It seems to need adjustment but I have no clue on where to
>start. I remember these shifters being a little loose back in th day
but we
>replaced with a hurst shifter. I need some help on this one.
-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]