1st laugh out loud of 2003
ThankX
----- Original Message -----
Sent: Thursday, May 29, 2003 4:33
PM
Subject: Re: [Chevelle-List] off subject
changing jobs
To unsubscribe from this service you must first
purchase a Craft-O-Matic Adjustable Subscription Cancellation
Unit. The unit can be obtained from most hardware stores and dental
clinics. Be sure to obtain the proper permits to operate the unit from
the Nuclear Regulatory Commission and the Food and Drug Administration
in Washington D.C. USA. Be sure to carefully unpack the kit and place
each component in its accompanying mesh safety bag. Mount the
Pershing DF4 mesinator on top of the perforated Gerring Mach 77
refibulator and attach them using the eight-millimeter torque fork. Be
sure that the refibulator is mounted at a 66 degree angle and properly
dispersed so that it is flush with the curved section of the Pyrex
thistle tube. Place the four sections of the triangular separation
gear into the posture cylinder and lock them into place using the
band aid adhesive strip. Insert the wiggling pin into the wobbling
hole, making sure that it seated correctly. Place the D cell
battery and the eleven 9 volt batteries in the power chamber. The
device should be calibrated before operation using the optional
digital corkscrew accessory pack prior to operation. Insert the
digital corkscrew through the electronic combustion service chamber
using caution not to touch the reinforced tungsten igniter control
module and quickly turn the inverter drive to 28.6 degrees. Turn the
Craft-O-Matic Adjustable Subscription Cancellation Unit upside down
and hit the bottom plate with a 48-ounce ball-peen hammer while
shaking the unit vigorously. Force open the door to the incineration
valve compartment and set the pressure gauge to 719 psi. Close the
door and seal it shut with duct tape. The unit should now be properly
calibrated and ready to use. Before activating the Craft-O-Matic
Adjustable Subscription Cancellation Unit, you must first elevate it
to a height of 229 feet above sea level to insure that the unit
receives the proper oxygen level and barometric pressure. Point
the aerial to 17 degrees north by northeast to within the parameters
of the Telstar GS-2 weather satellite and apply pressure to the wing
shaft on the southern most section of the modular accelerator. Using
the special ratchet adapter supplied with the unit, rotate the heater
core to the "on" position. The "on" position has been obtained when
the green light begins to flash, signifying that the red light is
about to go off. Once the red light is off, flip the toggle switch
labeled "ON/OFF" to the "ON" position and count to 47 before logging
on to the system. Logon using your username and password and wait for
the prompt. Once prompted you must check the box with the
appropriate action you wish to take and then press the pressure
release button and turn off the compressor while turning the hand
crank at 231 meters per minute. Next, press control, alt, delete, caps
lock, shift, number lock, escape and tab simultaneously. Press
enter. You will have one second to complete the procedure. If you fail
to respond in the time limit allowed, simply purchase a new
Craft-O-Matic Adjustable Subscription Cancellation Unit and start from
the beginning. Please remember that this is the only way we will
accept for you to unsubscribe from this service. We have made
every attempt to simplify the procedure for your convenience. Failure
to comply with the unsubscribe policy will result in immediate
termination of your subscription so please follow the above directions
closely
Regards The Chevelle List
|