I had to make a few tweaks, but yes I think you will be right at 350 HP and 400 lb-ft torque. I used Dyno2000 and was able to set the engine to 355, 10.5:1, Summit-1104 cam, increased lift to 0.496", selected a dual plane manifold, 600CFM carburetor, small tube headers with mufflers, and I had to sub in the GM 462 head because I don't have a 292 in my dataset. I would assume that they are close, but I don't know. The 1.6:1 rockers will also change other cam specs a bit, but I did not modify duration and overlap by the few degrees you should get.
Peak HP: 361 @ 5,000 RPM Peak TQ: 402 @ 4,000 RPM Here are the curves: http://ep.com/brad/ForumPix/andregraph.gif And the table: http://ep.com/brad/ForumPix/andretable.gif If you have flow numbers for your heads (or can find a flow file), get them to me and I'll rerun the simulation. I have old style SBC head flow files for the 441 (76 cc chamber), 462 (62 cc), and 882 (76 cc) heads. Brad Waller ([EMAIL PROTECTED]) '66 Convertible | 327/dead | 4-speed | Wilwood Brakes | 245/45/16 BFGs '67 Chevelle | ex-SS396 | 355/700R4 | '79 F-Body Brakes > -----Original Message----- > From: [EMAIL PROTECTED] > Subject: RE: [Chevelle-list] My combo on desktop dyno. > > Med Vennlig Hilsen/Kind Regards/Cordiali Saluti > > André Broe Jensen > > Would someone be so kind to run my combo on their desktop dyno > > 355 cid > 10,5 compression > Summit 282deg cam. > Intake & Exhaust duration 224deg at 0,50” > Intake & Exhaust lift 0,496” with 1,6 ratio rockers > Camel humps 292 Heads 2,02 & 1,60 stainless valves, > Edelbrock Performer RPM manifold, > Edelbrock 600cfm Performer carb, manual choke > Hei Distributor with MSD coil and module. > > Will this make 350 hp??? > > Thanks ! > > André