Graham, When I set timing after having the dist. out I rotate the dist as it requires to get the engine started, set static timing about where the book says, get the engine up to operating temp and then set total timing by running the engine above three grand(or what RPM is needed for total mechanical advance) and adjust to where you hope to run it. Small blocks like around 36 degrees or so, but the key is to run the car and be sure you don't spark knock under load. If you do you are too far advanced. Every engine is different. My Pontiac 421 likes 40 plus degrees. There are many people on this list that know way more than me about tuning. Maybe someone can get you closer than me, but this method will work for most street engines. Mike ----- Original Message ----- From: "Graham Wooden" <[EMAIL PROTECTED]> To: "'The Chevelle Mailing List'" <[EMAIL PROTECTED]> Sent: Sunday, March 28, 2004 8:56 PM Subject: RE: [Chevelle-list] timing
Hi Dale, Yeah, ignition timing. Um, well, I remember the folks who degreed in my cam wrote down what the timing is supposed to be set at ... So much before or after top dead center. I just figured that there was some collation there - and I wish I could find that paper. Oh well. So I guess the timing has be done be feel eh? -Graham. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dale McIntosh Sent: Sunday, March 28, 2004 8:49 PM To: 'The Chevelle Mailing List' Subject: RE: [Chevelle-list] timing Are you talking ignition timing? Nothing to do with cam specs. Dale McIntosh I've stopped 3,877 spam messages. You can too! One month FREE spam protection at http://www.cloudmark.com/spamnetsig/ > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Graham Wooden > Sent: Sunday, March 28, 2004 6:31 PM > To: 'The Chevelle Mailing List' > Subject: [Chevelle-list] timing > > Hi Folks, > > I am in need to get my timing done, and for some reason I > lost the sheet of paper that when the cam was degreed in, > what was the mark for the timing. > So, with that ... I do have my cam specs. Can the timing be > figured out from it or would I have to go by 'feel' ? > > Intake Exhaust > Duration @ 050 224 224 > Lobe Lift 310 310 > Lobe Separation 104 112 > Seat Duration @ 006 276 276 > Gross valve lift 465 465 > Valve lash (hot) 0 0 > Degree #1 intake lobe to: 104 ATDC > > Any help would be rad, thanks! > > -Graham. > http://www.projectchevelle.com/ > > >
