Acording to the assembly manual the neg. goes to the front pass. side of the
block. The positive is held in place by 1 clip to the frame directly down
from the battery and 2 clips on the oil pan. If it is an auto you can tie it
up to the trans cooler lines. Treans.
----- Original Message -----
From: "chevy" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>; "The Chevelle Mailing List"
<Chevelle-list@chevelles.net>
Sent: Sunday, May 22, 2005 3:50 PM
Subject: [Chevelle-list] 2 door wagon
i have a 65 chevelle 2 door wagon for sale. the car is in rough condition.
needs floors and quarters and more. has all the rear windows and trim.
located by peoria illinois. call me at 309 364 3352. can call late at
night
----- Original Message -----
From: "Crazy Rusty" <[EMAIL PROTECTED]>
To: "'The Chevelle Mailing List'" <Chevelle-list@chevelles.net>
Sent: Sunday, May 22, 2005 10:28 AM
Subject: RE: [Chevelle-list] Routing of Positive Battery Cable on 69
Chevelle
Oops, I misread the question. I'll go out and take a pic of where mine
are
attached.
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Crazy Rusty
Sent: Sunday, May 22, 2005 8:16 AM
To: 'The Chevelle Mailing List'
Subject: RE: [Chevelle-list] Routing of Positive Battery Cable on 69
Chevelle
As far as I know it goes to the starter. On mine it takes a slight route
detour and goes to a remote solenoid. I could be wrong but I'll double
check when I go out to the garage later.
All I have is a pic of the solenoid route -
http://www.crazyrusty.com/vehicles/chevelle/projects/electrical/images/clean
er.jpg
- JB
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Mark Schwartz
Sent: Sunday, May 22, 2005 1:15 AM
To: Chevelle-list@chevelles.net
Subject: RE: [Chevelle-list] Routing of Positive Battery Cable on 69
Chevelle
Hi All,
I would sure appreciate some help. (A picture would be wonderful too...
The
battery cables in my 69 chevelle are just wrong. By wrong, I mean that
they
don't have any clips to attach to the frame to hold the cable in place.
The
cable is dangling next to the tie rods ends. Can someone tell me where
to
route this so the movement of the tie rods doesn't hit the battery cable?
thanks
Thomas
69 Chevelle