Hi Nigel: Thanks for the reply. I don't see a settings tab. When I "download from radio" and try and click on the "Properties" tab there is no response. I hope that would be an area where I could increase the number of channels to the specified 200 that is supposed to be available. It's like the radio is stuck on alphanumeric mode.
On Fri, May 1, 2020 at 3:01 PM Nigel A. Gunn G8IFF/W8IFF <[email protected]> wrote: > Is there a switch in the SETTINGS tab? > > On 01 May 2020 at 17:52 AS <[email protected]> wrote: > > Only 99 channels with Kenwood TM-281A > > Hi All: > > Been trying to use CHIRP to program my Kenwood TM-281A. This radio is > specced for 200 channels but, according to literature, reverts to 100 > channels when names are used. > > When I download from the radio it only allows me 100 channels (0-99), even > when I import a CSV file with the names deleted. When I click on the > memory range I am unable to go past 99 (upward arrow greyed out). > > Is there a way to open up the memory to 200 channels? > > Thanks! > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Nigel Gunn, W8IFF at [email protected] > To unsubscribe, send an email to > [email protected] > > > > > Nigel A. Gunn, ///shoulders.outwards.resolutions tel +1 937 825 5032 > Amateur Radio G8IFF W8IFF and GMRS WRBV701, e-mail [email protected] www > http://www.ngunn.net > >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
