hello again, I made a programming cable fom a pl2303 adapter and 2.5mm 3 pin jack, I connected the pl2303 tx to radio rx and pl2303 rx to radio tx, unfortunately I only see this at chirp console:
ERROR: Giving up Traceback (most recent call last): chirp.errors.RadioError: No response from radio What is happening? Best regards. El dom., 10 may. 2020 a las 20:04, Ernesto Xload (<[email protected]>) escribió: > A lot of thanks David, > > El mar., 5 may. 2020 a las 3:58, David Evans (<[email protected]>) > escribió: > >> Ernesto, >> >> Have you used Chirp with other radios? >> >> I have a Kenwood TH-D7, as well, and Chirp reads and programs it well. >> Chirp handles the TH-D7 a little differently than most radios. You do not >> have to write your data to the radio because it is written to the radio as >> soon as you enter it into Chirp. >> >> Thanks, >> David >> kd7uch@ <[email protected]>gmail.com >> >> >> >> >> >> >> On Mon, May 4, 2020 at 2:59 PM Ernesto Xload <[email protected]> wrote: >> >>> Hello, >>> >>> How can I read Kenwood my TH-D7 fron CHIRP? >>> >>> Best regards >>> _______________________________________________ >>> chirp_users mailing list >>> [email protected] >>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users >>> This message was sent to David Evans at [email protected] >>> To unsubscribe, send an email to >>> [email protected] >> >> _______________________________________________ >> chirp_users mailing list >> [email protected] >> http://intrepid.danplanet.com/mailman/listinfo/chirp_users >> This message was sent to Ernesto Xload at [email protected] >> To unsubscribe, send an email to >> [email protected] > >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
