Hi David, On Wed, Dec 29, 2021 at 5:18 PM J. David Aten <[email protected]> wrote: > > I recently tried to roll back the driver for a Prolific cable, but couldn't > get my version of Windows 10 to allow this. The tab for "roll back driver" > is grayed out. I tried to use the update driver, which I had downloaded the > correct driver from Miklor, to load in. It kept saying that I had the best > driver. Is there a workaround for this, now? I finally found my FTDI cable, > and then didn't have any problems. But, I do have a couple of Prolific > cables (no doubt fake), so, I would like to be able to use them. Thanks, if > anyone has a solution.
Follow the instructions here: https://www.miklor.com/COM/UV_Drivers.php#install This is what I have been using since 2012. The same basic concept works for Windows XP (driver v2.0.2.1) and Windows 7 through Windows 11 (driver v3.2.0.0) when your programming cable identifies itself as having a Prolific PL2303XA chip. The latest Prolific driver available works for the newer Prolific PL2303TA chips. Jim KC9HI _______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
