The Abbree AR F8 has this concept, but as far as I can tell, it just stores the current A and B channel setting. So you can program it from Chirp, but once you change channel, that register is updated and will be remembered during power cycles.
I suppose it is useful if you reprogrammed a group of radios after every use? (And then left the keypad locked, and told everyone to stop messing with the buttons!) Mark On Mon 16 May 2022 at 14:34, Ken Hansen <[email protected]> wrote: > I just scanned the UV-5R manual and could find no mention of such a > 'feature' or 'setting', I suspect this is something enabled in the CHIRP > software interface that is not supported by the Baofeng radio itself. > > The closest function setting I could find were the "MDF-A" and "MDF-B" > that determine what is displayed (freq, ch, or name) for the A and B sides > of the receiver. > > Ken, N2VIP > > > On May 16, 2022, at 07:43, [email protected] wrote: > > > > Hi Folks. > > > > Have just set up my UV-5RE Plus with relevant channels and settings but > > one that is causing me a bit of a head scratcher in the Work Mode > > Settings is the MR A Channel and MR B Channel. > > > > Maybe I'm misunderstanding this but I set these two fields up to hold > > location 16 and location 60 as 'Defaults' so that no matter what channel > > I left it at when I switched the radio off, when I switched it back on > > again, it would revert back to the 'Defaults' > > > > If I have understood this facility correctly, it isn't doing it. If I > > move off a default channel using the up or down arrow then switch the > > radio off then back on again, it stays at the last positions - it > > doesn't revert back to the defaults. > > > > Have I misintrepreted this?? > > > > Regards > > > > Declan > > _______________________________________________ > > chirp_users mailing list > > [email protected] > > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > > This message was sent to Ken Hansen at [email protected] > > To unsubscribe, send an email to > [email protected] > > To report this email as off-topic, please email > [email protected] > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Mark Leyden at [email protected] > To unsubscribe, send an email to > [email protected] > To report this email as off-topic, please email > [email protected]
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected] To report this email as off-topic, please email [email protected]
