Well, It works the Device connected to the VLans ports works Ok, but the interface Vlan 1 on Catalyst A cannot see the interface Vlan 1 on Catalyst B.
Any Idea?? :-( saso pirnat escribió: > dalton wrote: > >> is the trunk showing up? >> >> Make sure its a crossover cable connecting them as well. >> >> repost your config, it didn't come through. >> >> -dalton >> >> On Fri, Mar 16, 2007 at 11:44:54AM -0400, Juan C. Crespo R. wrote: >> >>> Hi Dears >>> >>> I'm getting problems trunking two Catalyst 2950G, I try a lot of things >>> and I can't make it works. the VLAN 1 on both sides, can't make ping >>> each other, and neither Telnet or SSH, Anyone could send me a config >>> examples about trunking on two 2950G? >>> >>> Thanks >>> >>> this is my config >>> >>> _______________________________________________ >>> cisco-nsp mailing list [email protected] >>> https://puck.nether.net/mailman/listinfo/cisco-nsp >>> archive at http://puck.nether.net/pipermail/cisco-nsp/ >>> >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> > > > You should specify which vlans are allowed in trunk: > > interface GigabitEthernet2/3 > switchport trunk encapsulation dot1q > switchport trunk allowed vlan 1,10-25,354,456,845 > switchport mode trunk > mls qos trust dscp > > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
