Hi Scott, I'm not very good at this, but are you sure it's OK to connect a FR interface to an ATM interface? How is the conversion performed?
Can you ping across the link? Vincent > I have two routers 2600 and 7206. Attached together via two ports 1 DS1 > frame relay and 1 DSL directly connected (no PPPOE) aal5snap. > > On both routers I have the following ospf config > > 2600# > router ospf 1 > log-adjacency > redistribute connected subnets > network 172.16.100.0 0.0.0.3 area 1 > > > 7206# > > router ospf 1 > log-adjacency > redistribute connected subnets > network 172.16.100.0 0.0.0.3 area 1 > > SERIAL on 2600 > > interface serial 0/1 > no ip address > encapsulation frame-relay ietf > frame-relay lmi-type ansi > ! > interface serial 0/1.1 point > ip address 172.16.100.2 255.255.255.252 > frame-relay interface-dlci 16 ietf > > > On the 7206 > > Interface atm 3/0 > no ip address > ! > interface atm 3/0.1 point > ip address 172.16.100.1 255.255.255.252 > pvc 0/197 > encapsulation aal5snap > > > I have not activated any other interfaces at this point. I keep getting a > repeated interface down or detached error. Any pointers would be > appreciated? > > Thanks > Scott _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
