Sridhar Ayengar wrote: > I have a 7505 with an RSP2 running IOS 12.4. One of the boards is a > VIP2-50, and on that board is a PA-FE-TX and a PA-4E. The PA-FE-TX is > attached to my routed public network, and one of the ports on the PA-4E > is attached to my NATed private one. >
So you've got one side at 10Mbps... > Moreover, an SFTP file transfer moving a file from a machine on the > public network to a machine on the private network only transfers at > about 150KB/s. 150KBytes/sec = 1.2Mbps... I also noticed: > interface Ethernet2/1/1 > ip address 172.22.22.1 255.255.255.0 > ip nat inside > ip virtual-reassembly > full-duplex You've set the 10Mbps interface to full-duplex. What is on the other end? 10Mbps devices are typically half-duplex. If you have a duplex mismatch that would certainly slow down the transfers. Check error rates on both sides of that link. Jeff _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
