Is it a WIC-1DSU-T1? And you need a WIC-1DSU-T1-V2 for the 18xx/28xx/38xx series ... if it came out of an older router this is likely the case.
On 8/28/07, Ed Ravin <[EMAIL PROTECTED]> wrote: > > We just stuck a WIC-1DSU-T1 removed from service on a different > router into a 2801. The router says this upon bootup: > > %CFG-3-CARD_NOT_SUPPORTED: Slot 3: Unrecognized cookie format for > card!sslinit fn > > The version info is: > > Cisco IOS Software, 2801 Software (C2801-ADVSECURITYK9-M), Version 12.4(3f), > RELEASE SOFTWARE (fc3) > > > What could be going on here? We tried all three WIC slots, same > error. Is something basic like T1 WIC support missing from the image, > or do I have a bad or fake WIC? The "show diag" info is below: > > WIC/VIC/HWIC Slot 3: > FT1 BT8360 > WIC module not supported/disabled in this slot > Hardware revision 1.3 Board revision C0 > Serial number 28156561 Part number 800-03279-04 > FRU Part Number WIC-1DSU-T1= > > Test history 0x0 RMA number 00-00-00 > Connector type Wan Module > EEPROM format version 2 > EEPROM contents (hex): > 0x20: 02 11 01 03 01 AD A2 91 50 0C CF 04 00 00 00 00 > 0x30: 60 00 00 00 02 05 14 01 FF FF FF FF FF FF FF FF > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
