Hi, i have messed up my router (3640) with a config-reg value of 0x3922 disabling the break sequence. Now, I am unable to get into ROMMON mode to change IOS. The current IOS does not detect my Ethernet module. Also, when I try to enter config mode it says:
Router>enable % No password set Router> When I try to boot the router without any Flash in place, it still does not go into ROMMON mode and just sits idle. Is there a way to reset the config-register using junpers ? Regards, Junaid. _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
